Hi guys,
I already perform tool offset checking on our LB3000's, but robustly checking them on the Multus is a little more complicated.
If the operator is following procedure and using the touch setter, or AUTO CAL, you should be able to read out the offsets for any position / mode and check those. But, I want to protect against an operator manually entering a bad value in just one position, so I need to check everything x8:
- BT=0 / BT=1
- M602 (A) / M603 (B)
- G140 (main) / G141 (sub)
I'm just not seeing a way to specify these individually stored offset positions, using system variables:
Any ideas?