Re: Need Help! Bought the UC100 USB motion controller- Having small issue with mach3
Does your machine jog in the right directions? From 0,0,0 you should jog right with your right arrow, forward with the up arrow, and the z axis should travel up with a Page up. Your 0,0,0 position should most likely be at the bottom left of the table. Next do some basic measurements, ie., see if it moves an inch or 10 mm with a simple ruler. If these are correct your problem is most likely in your CAM set up or post processor.
Oh, I see you fixed it, great!
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)