When trying to switch from inside clamping to outside clamping i get an Alarm in the controller when trying to close the chuck.. (Alarm A, chuck open/close)

When flipping back to inside clamping it clamps and unclamps just fine..

So looking at the solenoids in the rear i realize the left one of the pair dont activate as it should.

Outside clamping "On" results in this.
Attachment 470064

Inside clamping On and Clamped results in:
Attachment 470066

Inside clamping On and Unclamped results in:
Attachment 470068

The left solenoid in the picture missing a light is "cold" to the touch, and the other three "ends" of the two solenoids are warm to the touch so i think it might be dead or a fuse or a relay..

Do anybody know if these are relay activated?? And or if they have a fuse? its a 1A solenoid so not sure why it would be fused.. but relays for sure.

Kindly // A