The job I bought this for got done another way, but now I have another job where it might be useful. I finally hooked it all up and put it on the machine table.

Hooked it all up. No issue really other than being quite an exercise is advanced yoga positions inside a full enclosure. Filled it with oil, and filled the oil port. I actually over filled it with oil. I guess I wasn't looking at the moment it passed the site glass and then started pouring out below the table. Then per the instructions I backed out the adjustment screw, and fed it back in until felt a bit of resistance. I felt the motor turn a tiny bit as I took it in another 1/4 turn per the instructions. All seemed good.

However, there is a problem. When rotating in the A(-) direction (clockwise when looking at the front of the table) it runs great at a screaming 3-2/3 RPM. When running in the A(+) direction (counter clockwise when looking at the front of the table) it sometimes chatters and even stalls.