Hi all, ok, so I did something dumb a bit ago that, even dumber, I do not know how to remedy. 770M, PathPilot. I’m in the middle of a program and at the end of a tool cycle, ready to put next (final!) tool in spindle. But for some fool reason, I took the part out of the vise! And quite lost my x-position, doh. So what I need to do is clear enough to me: put the Haimer back in and get the part clamped back in the vise again correctly in x. But I do not know how to properly “halt” the program so that I can put the Haimer back in, etc, and then resume the program to finish with the final tool cycle. How do I go about this properly, please?? Thanks much—-C. Hale, Lafayette CO