Hi hope someone can help. I just aquired an older extron mill has a titan DNC interface on it to send to the machine. No matter what i try i can seem to get it to read the usb when i hit RS232 then Read on the controller Ive looked at the settings in the machines manual for the rs232 Port -com1 data bit -8bits stop bits-2 bits Parity check - none baud-9600 mode- terminal codes -ASCii

Ive tried adjusting these in the hope it might do something. but nothing downloads Im not sure ive got the right post processer yet but have tried a few different ones seen im told its not fanuc based but simlar.

I have tired sending from the machine to the usb but nothing also. last resort i found what i think was the cable for it ( 9pin ) tired that but nothing

Love some help after 20 years of as a manual machinist im a fish outa water with this.

Thanks