3.2kw Jianken 4 pole and Fuling 5.5kw Vfd. Details are in my other thread.

I have a 2.2kw non atc spindle (220v 1 phase, 2 pole,24k) barely running with the Fuling Vfd .

problems:

1) It seems to run ok in vf mode, but a little wierd in svc.
2) running from the keypad only, no jog, not speed change with pot, only by changing H value.
3) as per another thread, changing motor parameters causes other to change, but tuning is locked out

I would like to get at least the freq changing solved before going much further.

What is the best way to upload my parameters, or is there a generic cheat sheet circulating around here?


Also, I am thinking of putting the vfd in a steel enclosure but I would have to take the keypad out of the plastic enclosure and mount it elsewhere.

I have a steel enclosure with fan, filters, etc that might keep the vfd happy, dust, oil, flood coolant free.

Any thoughts on this?

thanks in advance.