I mostly cut P20 toolsteel on my Fanuc EDM. The problem I am having is that whilst trying to cut a piece 60mm thick the feed rate is painfully slow. What can I do to make it go faster?
I mostly cut P20 toolsteel on my Fanuc EDM. The problem I am having is that whilst trying to cut a piece 60mm thick the feed rate is painfully slow. What can I do to make it go faster?
just kidding, but one way to look at this is to be proud that it takes 60mm thickness without breaking the wire
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg