[kstrauss]

I have been asking Tormach for TTS ER11 holders for years since the smaller collets would make it easier to get coolant to tiny cutters. Has anyone experience with these: https://www.ebay.ca/itm/224685320975 ?

[popspipes]

I have been asking Tormach for TTS ER11 holders for years since the smaller collets would make it easier to get coolant to tiny cutters. Has anyone experience with these: https://www.ebay.ca/itm/224685320975 ?

I have bought the er20's and er16's from ebay sellers and they are all acceptable, but I dont build aircraft parts........... These were in sets of 10 which made them really affordable.

https://www.ebay.com/itm/wholesales-...8AAOSw5cNYYy0W

[kstrauss]

Sadly "CURRENTLY SOLD OUT"

[MichaelHenry]

Shars sells an ER11 collet tool holder with either 1/2-in or 5/8-in straight shanks - maybe bush one of those up to 3/4" with a TTS collar?

[Mooser]

There's some on evilbay
M
https://www.ebay.ca/itm/224685320975...cAAOSwg5hhpUeb

[kstrauss]

There's some on evilbay
M
https://www.ebay.ca/itm/224685320975...cAAOSwg5hhpUeb

I ordered two from that seller on evil bay. They claim to have shipped. I'll report here when they arrive.

[kstrauss]

My TTS ER11 holders arrived today. Based on supplied tracking information they shipped quickly but delivery was somewhat slow. The vendor is in the US and I am in Canada plus I suppose that Christmas parcels are also a factor.

A quick check in the mill spindle with a 0.0005 DTI inside the ER taper looks pretty good. One holder gives a TiR of about 0.0005 and the other holder barely wiggles the indicator.