when I post out, how can I edit the cncmasters inch post-processor to post out to more than one tool? right now it only does one. and I have to post out other tools separately .
anyone else have this issue?
when I post out, how can I edit the cncmasters inch post-processor to post out to more than one tool? right now it only does one. and I have to post out other tools separately .
anyone else have this issue?
If your controller supports tool change, just uncoment highlighted line by removing "+" sign in front of it.
Attachment 464932
Post provessors are located at c:\ProgramData\Vectric\Aspire\<yourversion>\PostP\
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.