I was wondering if anyone has experienced a jumpy axis on a router table that was caused by the Motor Tuning in Mach.
Could a miss tuned motor somehow cause a slight jumping effect that is more pronounced with faster speeds?
I am pretty sure there is nothing with the gears or Nema 34 motor. It just seems as if there is a possible internal fight happening, but I could be crazy as well.
I am not losing steps nor is there any kind of noise, but you can see the table shake slightly.
The noticeable shake is at a speed of say around 120ipm but if you slow down to around 60-80ipm it is a lot smoother.