Originally Posted by
StanMyers
Good morning, Thanks for adding me.
Disclosure, I am fairly new to machining, my job sort of forced me into it.
We have a HAAS TM3P mill. We use Mastercam software. I am having an issue with the feed rate not seeming to change. I wrote a mill program for a part, feed rate was 91 IPM. I then wrote the program again, changing end mills and parameters, and the new feed rate is about 150 IPM. Problem is, the run time is exactly the same for both programs, about 5 minutes. I have searched for parameters that might be limiting the feed rate, the only one I have found is #59, and it is set to 400. Any help or suggestions would be appreciated.