Hey guys I am changing out the clunkie toggle forward /off/ reverse switch with the rotary style for a few reasons 1 it has worn out and is not working properly and 2 when it was working it was hard to flip from each position. I has a wiring diagram from the grizzly G0765 that uses this type setup the lathe I have is the cj0618 7 x 14 I have attached both types of wiring diagrams i am having problems getting the rotary switch wired up the only wire I am concerned with and not sure what or where it goes is the #5 wire in the colored diagram. If someone can take a look at it and explain this wires function it would help . There is a filter board that is a bit different from what's in the colored picture but all the wires that are labeled with a location ( i.e. L2, A+ ) i jave been able to route to the proper location on the rotary switch it is the wires that just have a number rather than a function is where I am having issues... any help is appreciated