Hi Peter, Did PP load all the way up to the main screen ??? IF so I can walk you in from there. This would be easier with email if you want. AS to the spindle we always use a S/D >> 0-10vdc card. But you can use a PWM >> 0-10v as well just have to take some code out of teh Hal file and add some code to the HAL file. BUT lets get PP where it loads up correctly first.

So you used the 1100M ? that has a lot of safety stuff added. THe one I use is from the OLDER versions list on the setup page 1100 S3 with the highest 3 diget s/n THat version is the last version that they used the 7i92 card in.

I am running from memory now as I sent out the last controller I had a card for. Except for my mill and I can use that if needed to walk you through.

Baby steps , (;-) TP