[sidestreetwaif]

Hello all,

I've been using CAMWorks for a couple years now, and while it works well ~95% of the time, occasionally I'll run into something that stops me dead for a while until I can figure it out. This time it's a pattern projection operation cutting unwanted grooves into a flat, sloped face. I can't figure out why it's doing this to me, and it's driving me nuts. Here's some pictures of the issue: https://imgur.com/a/4ilPoPv

What things might I be able to try? I'm going crazy trying to figure out what I'm doing wrong.

Thanks!

Try increasing the diameter of the tool by 10-15 percent. It can't be a software problem. It has to be a deflection problem. the tool is too weak