I have a laser machine 60w. I keep having to adjust the distance from the head to the material too often.
Tried leveling the platform but still happening. And all the lenses are aligned.
Tried it with different materials but still..Heeeelp please
I have a laser machine 60w. I keep having to adjust the distance from the head to the material too often.
Tried leveling the platform but still happening. And all the lenses are aligned.
Tried it with different materials but still..Heeeelp please
I had to match mine to the laser nozzle in all 4 corners. Using a level gave me the same results as you
Sent from my SM-G988U using Tapatalk
Hi,
I make a lot of circuit boards using an engraving tool to isolation route the traces. It is very sensitive to height variations, more than a few um and either the tool
cuts to deeply or skims over the top without cutting the copper layer at all. I use a freeware software utility called Autoleveller. It generates a probing routine, then probes
the target material and records the Z heights. It then uses the Z heights to manipulate the G code so that the Z axis goes up and down minutely to follow the surface.
I have used it daily for seven years, works a treat.
It may be that you can adapt it to your use. The source code is published so you could use the same idea and write your own code.
https://www.cnczone.com/forums/pcb-m...-software.html
Craig