We use 3 digit USB Floppy emulator on all cncs. They are working fine.
An error occours when i reinstall software.
ERROR 334 Floppy disk recalibrate
Why?
I tried all jumper combinations and same error.
We use 3 digit USB Floppy emulator on all cncs. They are working fine.
An error occours when i reinstall software.
ERROR 334 Floppy disk recalibrate
Why?
I tried all jumper combinations and same error.
"Imagination is more important than knowledge."
osp-7000?osp-u100?
It's an OSP-700 with Gotek emulator https://www.ebay.com/itm/300723408804
I can save and read program files in both Okuma and MS-DOS format.
I get the alarm (ERROR 334 Floppy disk recalibrate) when I try to boot the battery utility.
I successfully used the same disk image and identical emulator on another machine with the OSP-700
Only difference I've found so far is the working machine had 1998 software and the machine I'm working on now was updated in 2006. Maybe the battery reset utility isn't used anymore?