I am looking for a Post for Mastercam (2021 in use currently) to send ISO programs to
a Heidenhain TNC 415 controller on an CorreaAnayak 4-axis milling center. If available
please send to [email protected]
I am looking for a Post for Mastercam (2021 in use currently) to send ISO programs to
a Heidenhain TNC 415 controller on an CorreaAnayak 4-axis milling center. If available
please send to [email protected]
Did you find post?I need it too
No responses on a post file.
I found post with 4axis for mastercam, but i not sure if it work propertly. if anyone needs it let contact me EMAIL: [email protected]