586,080 active members*
3,485 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Tormach Personal CNC Mill > Machine keeps shutting down/ going into reset mode

Thread: Machine keeps shutting down/ going into reset mode

Results 1 to 2 of 2
  1. 03-25-2022, 09:49 PM #1
    victhefish
    victhefish is offline
    Join Date
    Mar 2022
    Posts
    2

    Machine keeps shutting down/ going into reset mode

    I start running my gcode, and after a minute or so the machine stops, wants to be reset. States "communication error, check cabling and restart".
    Thought it was the doors safety catch , but that only stops the spindle. I reset and run again, this time runs for 8 minutes (last one was 5).
    Everytime it cuts off at a different time/spot/event.
    This is a Tormach 44o and enclosure

    Any ideas?
    Reply With Quote Reply With Quote
  2. 03-28-2022, 01:55 PM #2
    soofle616
    soofle616 is offline
    Join Date
    Mar 2020
    Posts
    218

    Re: Machine keeps shutting down/ going into reset mode

    Have you checked the cable between the controller and the machine? Could have vibrated loose.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Absolute cords reset in handle mode
    By quasarix in forum Fanuc
    Replies: 15
    Last Post: 05-15-2019, 11:25 AM
  2. Reset Buffer in Remote/Tape mode (drip feeding) after a feed hold
    By northernmach in forum Fanuc
    Replies: 0
    Last Post: 04-01-2018, 01:25 AM
  3. Siemens 840c controller stuck in Reset mode (Hyundai Hit 18S)
    By leftfooter in forum Hyundai Kia
    Replies: 3
    Last Post: 07-16-2014, 03:49 AM
  4. press reset emer mode active
    By skidmarx in forum Benchtop Machines
    Replies: 1
    Last Post: 05-21-2010, 12:18 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules