So I've had this machine since it was new. I run some short run production using bar stock material...without a bar feeder.
Using this code;
....
M5M9
G0Z.005
X-3.4
M84 (SET PART)
M00
G0X20Z20
M2
At the M84 I slide the bar manually to a stop and close the collet using the foot pedal....however, the M84 has become lazy....and even stranger to me, maybe just coincidence, but when I open the door then the M84 will complete. But if I don't open the door, it may take 2-3 seconds for the M84 to complete. System pressure is good, chucking pressure is ~200, the proximity sensors on the drawtube are set good.....and it runs fine at start-up but as the day progress' get to this issue.
Using the foot pedal doesn't open the collet any quicker either.
Thoughts?