VMX1 2007. This error is displayed: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM but in Control panel the PCI XMP Motion Controller is "working properly" !!!??? Verified 24VDC prezent at the RMB module.
VMX1 2007. This error is displayed: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM but in Control panel the PCI XMP Motion Controller is "working properly" !!!??? Verified 24VDC prezent at the RMB module.
Your 24v supplying the RMB module has gone/shorted to ground.
24 Vdc is ok but the state of the six LEDs is as follows:
IN/LINK - off
IN/CYCLIC - blinking
OUT/LINK - off
OUT/RPT - off
FPGA - blinking
BOOT - on
24 Vdc is ok but the state of the six LEDs is as follows:
IN/LINK - off
IN/CYCLIC - blinking
OUT/LINK - off
OUT/RPT - off
FPGA - blinking
BOOT - on
There is a listing available from Hurco that will tell you what the LEDs mean. You’ll also need to see what the LEDs on the sockets of the XMP card are doing too.
The LEDs on the sockets of the XMP card are all OFF.