586,089 active members*
3,845 visitors online*
Register for free
Login

Thread: Wierd Error

Results 1 to 6 of 6
  1. 05-08-2022, 12:30 PM #1
    Feri56
    Feri56 is offline
    Join Date
    May 2022
    Posts
    4

    Wierd Error

    VMX1 2007. This error is displayed: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM but in Control panel the PCI XMP Motion Controller is "working properly" !!!??? Verified 24VDC prezent at the RMB module.
    Reply With Quote Reply With Quote
  2. 05-09-2022, 06:20 AM #2
    bloke
    bloke is offline Member
    Join Date
    Jun 2008
    Posts
    1104

    Re: Wierd Error

    Your 24v supplying the RMB module has gone/shorted to ground.
    Reply With Quote Reply With Quote
  3. 05-09-2022, 07:10 AM #3
    Feri56
    Feri56 is offline
    Join Date
    May 2022
    Posts
    4

    Re: Wierd Error

    24 Vdc is ok but the state of the six LEDs is as follows:
    IN/LINK - off
    IN/CYCLIC - blinking
    OUT/LINK - off
    OUT/RPT - off
    FPGA - blinking
    BOOT - on
    Reply With Quote Reply With Quote
  4. 05-09-2022, 07:34 AM #4
    Feri56
    Feri56 is offline
    Join Date
    May 2022
    Posts
    4

    Re: Wierd Error

    24 Vdc is ok but the state of the six LEDs is as follows:
    IN/LINK - off
    IN/CYCLIC - blinking
    OUT/LINK - off
    OUT/RPT - off
    FPGA - blinking
    BOOT - on
    Reply With Quote Reply With Quote
  5. 05-09-2022, 07:53 PM #5
    bloke
    bloke is offline Member
    Join Date
    Jun 2008
    Posts
    1104

    Re: Wierd Error

    There is a listing available from Hurco that will tell you what the LEDs mean. You’ll also need to see what the LEDs on the sockets of the XMP card are doing too.
    Reply With Quote Reply With Quote
  6. 05-10-2022, 10:49 AM #6
    Feri56
    Feri56 is offline
    Join Date
    May 2022
    Posts
    4

    Re: Wierd Error

    The LEDs on the sockets of the XMP card are all OFF.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Wierd error
    By L98FIERO in forum BobCad-Cam
    Replies: 5
    Last Post: 01-16-2017, 06:51 PM
  2. Wierd CNC problems
    By averageJoe576 in forum CNC Machining Centers
    Replies: 1
    Last Post: 01-05-2016, 09:38 PM
  3. Had something wierd happen yesterday
    By Steve Seebold in forum Tormach Personal CNC Mill
    Replies: 1
    Last Post: 02-18-2013, 03:33 PM
  4. Wierd G31 system error - ideas?
    By la_coterie in forum Fanuc
    Replies: 6
    Last Post: 08-22-2006, 08:39 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules