[nemo1966]

OK so got 3 of these on a Denford Triac. Trying to get them running (nearly there) but the manual is driving me insane.
In this picture (from the manual)... These are my first servos.

I have asked on other forums but get the generic reply of servo on switch and away it goes. - it does not. Step/Dir configuration (control)

https://www.cnczone.com/forums/attac...d=480254&stc=1


So in the picture I assume it shows the starting state of the servo connections before the "Trial Run". (page 24 - 25 in the manual)

It shows:
"Servo ON" as OFF (open switch)
"CL" as ON (closed switch)
"INH" as OFF (open switch)
[B]
But then in the instructions it states - "Make a deviation counter clear (CL) signal to clear release (L -> H)."???? So I am assuming the "ON" state at the start is "LOW". I would have assumed "LOW" was OFF ?????

Also when it says signal to clear release - I assume this is flip the switch???? Not flip it on and off to reset a counter????

Do I have to run through this procedure everytime I start the servos??? Seems strange.

Anyone please... the manual is driving me nuts.?

Thanks