[ardenum]

Okay, gotcha, where do you normally get your grippers?

from acrow. If I recall the bt30 ott style was about $160 for a sample. I got one from aliexpress though, didn't wanna deal with the B2B shenanigans just for one piece. After looking at it physically I think I'll be making my own from now on. That's because I'll also be repurposing their drawing for a pallet clamping system. Did you get that drawing from them?

[gloveless]

from acrow. If I recall the bt30 ott style was about $160 for a sample. I got one from aliexpress though, didn't wanna deal with the B2B shenanigans just for one piece. After looking at it physically I think I'll be making my own from now on. That's because I'll also be repurposing their drawing for a pallet clamping system. Did you get that drawing from them?

I haven't done it yet, we just had our newborn so I've been busy and tired and not tired all at the same time haha
But I hope to revisit this or next week and get those drawings sorted out. I did finally figure out how everything should be correct as far as the 7:24 ratio goes, I got the taper finished and everything the only other thing I'm figuring out is those clamps, trying to make sure we have enough tolerance to fit the clamps, I have been looking and it seems the sizes do vary so its a bit misleading right.