Hello again everyone
Well I got the z axis figured out and it homed a couple of times. Came in to start it today and now the y axis light is red on the servo drive. Also getting an error message again. I assume it doesn’t mean that the servo drive is necessary bad? Where would one start looking to find the problem? I took the way covers off the front of the machine and the cavities where just full of shaving’s. Cleaned most of that out but still nothing? Is there a way to test the limit switches? I can see 2 of them but very hard to get too. The machine is a vm17 b serial number 4725. I would appreciate any help you could give me on getting started with this problem. I would someday like to be able to use it lol. Thanks again.