Hi there
Looking to replace a z axis motor and drive, but my motion controller (csmio IP/A) only outputs +-10v, because i wanted to keep the X & Y axis brushed dc servo motors and drives.
Really struggling to figure out which servo drives actually accept analogue +-10v signals, as the descriptions are often very vague

I was looking to buy this kit instead of messing around trying to get the old brushed dc motor and 24v encoder to work with a new drive,
its a ACS606 servo drive and a BLM57180 motor
https://www.ebay.co.uk/itm/314001264...kAAOSww7VhpzBo

was also considering ac servo motors but cant find any with a small enough shaft.

cheers for any help

fin