Mach 3,ESS controller board, Gecko 540 stepper controller.
I built my CNC over 12 years ago and am ready to add a laser engraver to its capabilities.
A few years ago I purchased a simple laser set up with PS but no way to control the power or the on/off cycle. So all I have done with it was to plug it in once and it does power on.
PS PRODUCT DETAILS:
CCDSTAR, Model EZ-1225 2018B,
INPUT: 100-240VAC
OUTPUT: DC 12 V 2.5A
LASER MODULE:
Model FA02
PS 12VDC
DRIVE MODE: internal ACC
WAVE LENGTH 445 nm
OPTICAL POWER 2500mW
SN. 1804EPXZ
All I want to use this for is laser etching, and I would like to do this without removing any of my present CNC controller system shown above.
Is this add on possible to my existing system, and how to integrate/ wire it up.
Thanks
Hager