I'm having trouble with Mach3 and G-Code.
The computer I use for design has Mach3 installed on it and the results from this code shows just fine.
But when I load it on the PC that is actually connected to the CNC, one circle is HUGE!
its line 57 on the attached G-Code file: I had to rename the file extension to .txt so it will post here
G2 X74.3 Y34.353 I-26.675 J9.747
Units are in MM
that gcode line is supposed to make a 2in circle (50.8mm)
But on the CNC pc it tried to draw like a 2-foot circle!
Is there a setting I may have differently between the two?