Originally Posted by
geppo_it
good day Tom,
after a long pause I finally finished my lathe, mechanically and electrically.
Everything works smoothly: external buttons, handweels, rotary tool changer, spindle and so on.
Problems come when I try to launch a job and that is:
I open path file (TR_PROFILO_1.txt), it's all right.
I flag "Simulate", "run" and the path is executed and displayed in the graphics window without errors (Simulation.png)
I press Run button and I get G-Code error (run error.png)
The strangest thing is that if I run the same path with the "Single step" button most of the time I can get
to the end without errors, while sometimes I get the G-Code error as in automatic.
I'm sure I'm doing something wrong but I can't figure out what.
Some advice?
Beppe