If i command a M140 after the TOOL CALL will it create an issues? I would like to do this to make sure there is Z retract before rotary axis re-positioning on restarts.

*B0 C0 ROUGH WAVE GUIDE 1
;0.09375 EM 0.300 LOC
TOOL CALL 64 Z S30000
M140 MB MAX ****
;MAX - Z+.3247
;MIN - Z-.2048
CYCL DEF 32.0 TOLERANCE
CYCL DEF 32.1 T0.0001
CYCL DEF 32.2 HSC-MODE:0