[kolias]

I read the stepper motor drivers must be fed with individual cables from the PSU (power supply unit) but I have four drivers to connect and my PSU (48VDC, 12.5A) only has 3 terminals for POS and 3 for NEG. This means that in one terminal I will have to connect 2 drivers. The stepper motors are each 2.8A

My Y and A axis are slaved so I was thinking to connect them 2 to one terminal but I wonder if this is a good solution.

Any ideas which combination is the best?

[dazp1976]

I read the stepper motor drivers must be fed with individual cables from the PSU (power supply unit) but I have four drivers to connect and my PSU (48VDC, 12.5A) only has 3 terminals for POS and 3 for NEG. This means that in one terminal I will have to connect 2 drivers. The stepper motors are each 2.8A

My Y and A axis are slaved so I was thinking to connect them 2 to one terminal but I wonder if this is a good solution.

Any ideas which combination is the best?

Should be fine either way, any 2 doubled up.
You've gone for a good sized psu for it.

[kolias]

Should be fine either way, any 2 doubled up.
You've gone for a good sized psu for it.

Thanks for your time