I have a 770 pcnc, it has been used very little. I turned on the spindle today and it changed directions all by it self. Nothing I do will reverse directions. Not even the manual control panel will reverse it. Anyone else encounter this??????????
I have a 770 pcnc, it has been used very little. I turned on the spindle today and it changed directions all by it self. Nothing I do will reverse directions. Not even the manual control panel will reverse it. Anyone else encounter this??????????
Not sure if this helps..... I have a PC1100 that developed a similar issue after a near by lighting strike several years back. It took out the interface control board.
Have you checked cables and terminal connections?
Robert