Originally Posted by
forhire
The tool changer arm on my Matsuura MC1000V7 is rotating into position, the drawbar activates (release), but the arm doesn't drop down to complete the change. After a few seconds it generates the error:
3000 SEQUENCE TIME OVER.
CHECK NEXT SEQ. NUMBER.
SEQ. 11
IN MOTION OF ATC(M06)
2307 TOOL CHANGE DOES NOT FINISH IN 4.0 SECONDS.
3031 ATC INVERTER ALARM.
I suspect a bad solenoid but even after pouring over the manual I cannot figure out what activates the arm to drop. Any ideas?
I can remove the tool manually so the drawbar is releasing.