I got a second hand Yang 500 machining center just over a year ago. I powered it up and all I could move the table etc so I was happy.
I had to do a massive rearrange of my workshop as I needed access on all 4 side to the new machine. I basically had to do a complete refurbish of my machines and benches I had accumulated over 20 years. It took me just over a year to complete it.
When I originally got the Yang I replaced the batteries and Fanuc said they would last a year. The voltage on them today was quite low. My guess is that they will last a year while the machine is on every day.
Now when I powered it up, I get the message 'Not Support'. Mr google does not give any results for this?
Any suggestions ?
I did backup all the parameters last year.