[HCE]

Setting up dyn2 drives to a cnc drives axbb-e motion controller. The dyn2 manual states pin 11 is a disable pin with 5v applied. I received a wiring diagram to an axbb-e controller board and it calls pin 11 an enable pin active high. If it is a disable pin active high I fail to the logic of hooking it up to the axbb-e. Disable active high fails the what if the wire breaks test. So is it a enable or disable and active high or low?

[mactec54]

Setting up dyn2 drives to a cnc drives axbb-e motion controller. The dyn2 manual states pin 11 is a disable pin with 5v applied. I received a wiring diagram to an axbb-e controller board and it calls pin 11 an enable pin active high. If it is a disable pin active high I fail to the logic of hooking it up to the axbb-e. Disable active high fails the what if the wire breaks test. So is it a enable or disable and active high or low?

Active Low / High is up to how you are making that signal work so can be either

Normally Pin 11 is used to Enable the drive JP3-11=5v Enable, it will disable the drive when turned off

You could jumper Pin-12 to Pin-11 for the 5v to activate the drive, this should only be for a test though

If you have more than (1) drive, you can use a SSR to Enable all drives, using the (1) output from the control