[burs]

Hello guys, please remember the netiquette in the forum, thank you. I will have to tidy up a bit in a few posts in this thread.

[HayreAss]

Hello guys, please remember the netiquette in the forum, thank you. I will have to tidy up a bit in a few posts in this thread.

It feels like you really should just delete my entire reply, since the post I am replying to was deleted.
Hell, the only actual insult that I made is still there!

[mactec54]

It feels like you really should just delete my entire reply, since the post I am replying to was deleted.
Hell, the only actual insult that I made is still there!

I'm not the one that sets how you want to Format your programing, your machine uses RS274D code standards is where it all comes from, all machine controls / manufactures use this standard here if an article which starts almost from the begging which has been quite well done, this has been presented by Autodesk, and Note the Code Format this is the correct way all code should be written, so it does not confuse the control of which action it needs to perform, can it be in written in other ways yes it can and most do write it different from this example, the problem with writing it in a different format is you never know when a single word of code is not going to be read correct, the machine will either just do nothing or crash, they call it a (GLITCH)

https://www.autodesk.com/products/fu...entals-g-code/