Good evening Gentlemen,
I would like to receive Data from the incoming channel IN1.
For this purpose, I would like to manipulate the regular DLL-files
of the official open-source program of MACH3.
In addition, I would like to write my own c-code for receive DATA
from IN1.
For this purpose:
I need the addresses from the relevant DLL-file, at least I must open
the DLL-files first.
Is it a must to enable the IN1 or the controller board before I can
grab the Data per "bulk transfer"?
Now is the status of my controller board: the red light is flushing.
Is there any fundamental support for doing this?
Best regards