It has been awhile since I have posted or been active on this form. The issue at hand is that the 16 year old 150MHZ computer on my conversion has crashed. The computer that ran the mill was an AOpen AP5T mother board that used an Intel PP/MT150MHZ processor. The simplest solution would be to find another computer main board and swap it out. Can't find one on ebay. This build used a printer port and break out board to control the servos. Like I said it has been awhile since I have read on this form. Any suggestions of what I should be looking for to get my mill up and running again. I really don't want to change drives and servo's. A few links to get me in the right direction and an opinion or two is all that I am asking. Thanks for your consideration.


TonyK.
Ark1