Hi, I want to engrave text on the piece and I need it in the Times New Roman font. When I apply the engraving machining to the geometry, it mills out the entire letter. E.g. I use the letter "P", or anything with a boundary in the letter it mills out the boundary. How do I avoid this?
Results 1 to 5 of 5
-
12-13-2022, 01:30 PM #1
Member
- Join Date
- Dec 2022
- Posts
- 8
Maestro CNC engraving for SCM Accord 25 fx
-
12-13-2022, 02:56 PM #2
Registered
- Join Date
- Jun 2005
- Posts
- 1687
Re: Maestro CNC engraving for SCM Accord 25 fx
Get some single line fonts. You can find them for free online.
-
12-14-2022, 08:12 AM #3
Member
- Join Date
- Dec 2022
- Posts
- 8
Re: Maestro CNC engraving for SCM Accord 25 fx
Yeah I thought so, Maestro does have a few already on there. I need to find a good one because my bosses want engraving with the Times New Roman font.
-
12-17-2022, 08:23 PM #4
Ghost
- Join Date
- Dec 2008
- Posts
- 4548
I reverse engineered fonts to single line by vcarvimg the font to create a single, centerline toolpath, then using gcode2dxf (found on this forum) to turn the toolpath to dxf entities. I can then “flatten” the dxf to make it planar. Presto! Stick font from any font.
Originally Posted by Joel2001
Depending on your needs, you may have to clean up the little ears made from vcarve to leave only the centerline. Then agaian too, if you can vcarve, you kindof already have what you are looking for. I think i did this for someome who didnt have vcarving or something…
-
12-21-2022, 09:03 AM #5
Member
- Join Date
- Dec 2022
- Posts
- 8
Re: Maestro CNC engraving for SCM Accord 25 fx
That is a good idea! I will look in to that in the future. I managed to get the engraving to work properly now. Our tool was not set up correctly to begin with (conical mill set up as a straight cutter). If you highlight the letter with the boundaries to apply the machining, it will machine around that boundary to produce the engraving. Originally Posted by BurrMan
