Wondering what this code is, fusion 360 outputs, but my machine doesn’t recognize it, I can delete and the program runs. Haven’t found that code in a list yet.
Wondering what this code is, fusion 360 outputs, but my machine doesn’t recognize it, I can delete and the program runs. Haven’t found that code in a list yet.
What machine are you using with what control ?
Hy chris g270 is not critical, even if the lathe recognises it, it can run without it
Is equivalent to m109
270 71 72 are used to designate a machine mode : turning, interpolated milling, or non interpolated milling ( y axis ) / kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg
It’s on a L370mw - osp e100L - it runs fine without it. I wish I could find out what to change on the post to have it not in there
Hy chris, in case you dont figure out that post, i can fix your code automatically
It will scan and remove g270, or do whatever you wish / kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg