The mill developed a bad noise (I thought maybe the bearings in the motor) so I pulled the motor and had it sitting on the top of the mill running to see If I could get it to make the same noise without the load on the gear train.
Well my wife called for some help and the darn motor vibrated off and pulled the wires out of the motor starter control box. I have it back together but have no idea which wires go where. I have a wiring diagram from Enco but the colors are not correct or all shown. Any ideas?
David Munson
Thread: Wiring help.....
Results 1 to 2 of 2
-
09-18-2007, 04:09 AM #1
Registered
- Join Date
- Oct 2004
- Posts
- 3
Wiring help.....
-
09-24-2007, 05:21 PM #2
Registered
- Join Date
- Feb 2007
- Posts
- 2
My manual is not the best either, it says U1-T1, U2-T2. The third I dont know.
Reply With QuoteSimilar Threads
-
need help wiring
By dtman in forum Waterjet General TopicsReplies: 12Last Post: 07-14-2020, 07:10 PM -
Wiring help
By watsonstudios in forum Automation Technology ProductsReplies: 4Last Post: 06-13-2007, 05:32 AM -
wiring it all together
By russell in forum CNC Machine Related ElectronicsReplies: 2Last Post: 08-22-2006, 03:08 PM -
CNC wiring?
By stdly in forum CNC Machine Related ElectronicsReplies: 11Last Post: 02-18-2006, 09:44 PM -
P5 Wiring
By tintruder in forum Servo DrivesReplies: 2Last Post: 02-03-2006, 06:13 PM
Posting Permissions
