Originally Posted by
trooper55
Are you Just looking at it in the preview or when you go to cut it it wont do it. I know i have to ajust the max depth on my router to make it cut the full 1 inch be cause the materal wont be quite an inch
Both, in the preview the toolpaths don't go all the way to the bottom of the material and when we cut it it's stopping 1/4" short of the bottom. We cut through 1" and thicker material all the time and never have a problem cutting through, only have this problem when doing a relief for this sphere.
I even tried lying to the machine and telling it that the material was 1 1/2" thick and to cut the full 1 1/2" - but it still only cut 3/4" into the stock.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Check Out My Build-Log: http://www.cnczone.com/forums/showthread.php?t=6452