can anyone please help me that how to setup alarms in programme on mitsubushi.we are using fanuc controler and #3000 does stop the mc but dont generate the alarm.
can anyone please help me that how to setup alarms in programme on mitsubushi.we are using fanuc controler and #3000 does stop the mc but dont generate the alarm.
I'm guessing that a real alarm message is generated by the controller communicating with the PLC, so perhaps you'd need to edit the PLC. I haven't got a clue about PLC programming, although I did watch an amazing fellow create one for a Mits retrofit. He looked busy, so I didn't ask him any questions
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
What Mitsu Control.& or What Machine...#3000=1(Alarm Message) Should work....I've Found on all or citizens with M600series controls it works fine...execpt ussually the first couple character of message the don't show up on the alarm screen...so I trough a couple dummy charactes in..
#3000=1(**ALARM)