[scott4tg]

I am looking for someone that has had experience with Emmegi Diamant CNC Equipment. I have started a new job with a company that has a Emmegi T4A and an Emmegi Diamant. These machines are used primarily in window and door manufacturing. My past experience has been with Mazak and Cincom machining centers used in one off prototyping and small quantity manufacturing. If anyone knows anything about this type of equipment I have some specific question regarding setting up and programming these machines.

Thanks in advance

Scott

[Elpinchediablo]

I DO have experience on the Phantomatic 4 from Emmegi, may I ask what's the question you have?

[seanpmb]

Hello, I have a Phantomatic 3400 made in 2002. The mother board recently packed in (not the first time) so I purchased a new one from a local supplier. On reloading the software onto a new hard drive I am getting an error message that will not allow the cnc to start. Do you have any experience in this area?