Hi there
As seen in the photos, when I say go 1 mm, when it goes forward, it goes missing. How is the belt system calculation done? I did not fully understand the handbook you gave.
my Y axis
When 3mm goes, the bench goes 2.91mm.
When 2mm goes, the bench goes 1.92mm.
When 0.3mm goes, the bench goes 0.26mm.
My gear system:
Servo shaft: 24 tooth
ball screw input : 49 tooth
Ball screw pitch: 5 mm (1 turn)
Please check my gear parameter 1.jpg picture for y axis.I think,its is a wrong
I think my settings are wrong, can you calculate for me?
I am waiting for your reply.