info is all on the drawings ... lot sizes and material specs ...
thanks
Ben
info is all on the drawings ... lot sizes and material specs ...
thanks
Ben
sorry guys ... here is an updated drawings with tolerances ...
the hex needs to be sharp corners and made towards the high side of the 14mm standard
everything else is a loose tolerance
thanks !!!
Ben, would this be a repeating job? I will see about quoting these for you.
James
it is possible ... i do more work to them when i get them ... then take orders for them ... these are just blanks for a finshed product ...
here are the adapters finished
and here are the posts finished
i have made sets already and am just looking for someone to do blanks for me so i can design other parts ... which i will also be looking for someone to do ...
thanks again
Ben
Ben why not let us make you a completed part and you just sell them?
Bob
RCL Machine Services
because a completed part made from someone would cost me well more than what they can sell for ... and from the quotes i have recieved so far there is no way i could get a complete part made and yet sell for a profit ... i am not looking to make a ton of profit off these parts ... but the quotes i have recieved i would be losing money on ....
the adapters sell for $25 a set of 4 ... and the posts sell for $30 a set of 4 .... just to give you an idea of where the pricing needs to be
You need to increase quantities to get those prices. JM2C
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
When do you need these? Do you want the quote with shipping?