Hello All, I found this opto-output board, http://www.futurlec.com/DC_Opto_Output_8.shtml
but I don't know enough about it to know if it would work to opto-isolate my computer or not. Could someone take a look at it and advise? Thanks, Jack
Results 1 to 3 of 3
-
04-10-2007, 01:19 AM #1
Registered
- Join Date
- Jan 2006
- Posts
- 6
Need help from "electronic types"
-
04-10-2007, 01:58 AM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24221
On the surface it would appear they do provide isolation, but I would need a bit more info if I was using them, i.e. It seems they are either Input types or Output types, not combined.
Looks like IDC (ribbon cable) for input, this means it may be tricky to hook up to a parallel port directly without some wiring/customising of some sort.
If someone has already used them, they may be able to clear that up, but really a schematic of some kind would help.
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
04-11-2007, 03:09 AM #3
Registered
- Join Date
- Jan 2006
- Posts
- 6
Thanks for your reply Al. I've done a little more research and I think the CandCNC, MINI-IO-2 is what I need. Jack
Reply With Quote
Similar Threads
-
"low end" HF Spindle or "high end" router for about $1000?
By biomed_eng in forum DIY CNC Router Table MachinesReplies: 14Last Post: 01-06-2012, 07:15 AM -
BattleAxe "aka" Ball and Chain "aka" the wife.
By ZipSnipe in forum Community Club HouseReplies: 48Last Post: 05-18-2008, 03:53 PM -
Has anyone looked at the "JET" or "Shop Fox" manual machines?
By boosted in forum Uncategorised MetalWorking MachinesReplies: 12Last Post: 03-05-2007, 04:33 AM -
Vertical system "jerks" and "bangs"??
By REVCAM_Bob in forum Servo Motors / DrivesReplies: 5Last Post: 06-12-2006, 03:09 PM
Posting Permissions
