[robertbair]

Does anyone know if parameter settings can change the amount of program memory? I had been running programs before I accidently cleared all parameters I have restored parameters according to paperwork I found in the back door of maching. But now the controller says I dont have enough memory space to run the programs I have prevously been running.HELP!

[bob1371]

Does anyone know if parameter settings can change the amount of program memory? I had been running programs before I accidently cleared all parameters I have restored parameters according to paperwork I found in the back door of maching. But now the controller says I dont have enough memory space to run the programs I have prevously been running.HELP!

Parameter 901

Bit 1=1 (memory is 120M)
Bit 2=1 (memory is 80M)
Bit 3=1 (memory is 40M)
Bit 4=1 (memory is 20M)

This isn't in Meg's like you may be used to but I believe it actually referred to the length of tape 120M is 120 Meters.

Bob

[bob1371]

A couple more that may be of interest.

903 bit 5=1 (125 programs input)
915 bit 7=1 (200 programs)

Bob

[mroy0404]

this control is capable of 320m of memory

[robertbair]

So do i go to parameter 900 and change it to ?

[robertbair]

I need a little help with bit #s Do you mean for intsance 903 would be 00001000?

[Al_The_Man]

Bit #'s are 0 to 7 from right to left. i.e. 76543210
Al.

[robertbair]

Thanx Al
So where do i put the bit for the largest amount of memory and what line?

[Al_The_Man]

What was the original setting for the 905 parmeter bits?
and you may have had 915 bit7 set for 200 programs.
You set the PWE bit to 1 on the Setting screen and in MDI to change the individual bit #.
Al.

[robertbair]

I dont know what the original # was for 905.
I'll post back when i get to work here in about an hour.
Thanx