Hi All .,

Im upgrading my machine from open loop to close loop steppers..

And at the same time i have decided to do things properly this time round and get the electronics as good as i can.

Which brings me to shielding so i wont have to worry about interference and such.

Im putting in Leadshine CS-D808 drivers with CS-M23480 motors.

Now the power to the motors is shielded and the shield braid is tucked in with ground from the powersupply.

Encoder Cable is shielded and the braid from that is as far as i understand connected to the housing on the motor side and is not connected to anything on the driver side.

These 2 are easy for me to understand and do right.

Signal cables on the other hand i seem to find contradicting information on google about.

My signal cables are rj12 telephone cables and dont have any shielded brading ., therefor i have purchased these : https://www.hellermanntyton.com/prod...ip06/173-00600

But my question now is WHERE is this suppose to go.. Do i connect it on the driver side , do i connect it on the plc side ?

thanks in advance

Kristjan


g
Leadshine CS-M23480 Closed Loop Stepper Motor 8Nm 6A NEMA34