Hello all! I am converting my X2 in 3ax CNC. I have a few questions:
Thank you all in advance for your tips and advice!
- Is it possible to set up the X2 for rigid tapping?
- Does any one know if CNCFusion can supply ball screw/nut assemblies with Nook's precision ground (.001" p/ft.) screws? (I sent a few emails and no reply.)
- Did CNC Bridges ever get out any units? How are they? Any pics?
- Has anyone used the kit from http://www.thompsonmachine.net/mm2.htm ? (I sent them a few emails as well, with no reply!)
- Who has the best stepper/electronics kit? I just want "Plug & Pray". (My electronics talent is pretty much limited to seeing if the bulb is lit after I turn the switch on. I'm a machinist by trade posing as a mild mannered M.E. by day, and entrepreneur by night. I have built several PC's and done some soldering, but short of replacing a wall socket, not much else.)
- I want to mill 1018 plate, and 7075 aluminum to +/- .0010" . Is this possible on the X2 CNC?
wocowski